|
(801) 973-9310
|
|
|
| |
 |
|
|
|
 |
| Quality, Strength
and Security are what makes Martin Doors stand out from
the rest. We guarantee every door meets strict guidelines to
ensure you and your families security. |
|
Door
Section Hardware |
| |
*Exclusive,
reversible, heavy 13 ga Top Roller Bracket. "L" brace
if over 8' (2440) |
| |
|
high. |
| |
*Heavy
duty, 12 ga, Lock-on Bottom Roller Bracket. |
| |
*Patented
1.5" (38) inside flange with rolled edge for unsurpassed
strength and |
| |
longevity.
|
| |
*Reinforcing
strut with rolled edge. Optional under 12' 3" (3730) wide.
|
| |
*Multi
Contact, 17 ga structural support stiles with rolled edge. |
| |
*Full
length, 15 ga, Bottom Reinforcing Angle. 14 ga over 16' 2"
(4930) wide. With |
| |
the
weather seal, door height is increased by about 5/8" (16)
for better seal at |
| |
the
header. |
| |
*Durable,
double soft Bottom Weather seal. Cushions door when closing. |
| |
*Martin
Doors are made 2" wider than standard even foot increments. |
| |
~Gives
you a wider opening to drive through. |
| |
~Provides
a 1" overlap on each side for a better seal. |
| Long
Life Torsion Springs and Hardware |
|
| |
*Exclusive,
high quality galvanized torsion spring(s). |
|
| |
*Springs
built to 30,000 cycle minimum life (Wood
Line, Ranch and Hi-Tensil). |
|
| |
*30
year Limited Warranty (Wood
Line, Ranch and Hi-Tensil).
|
|
| |
*Lock-on
Side Bearing Bracket and Anchor Bracket. |
|
| |
*Spring
winding cones with safety caps. |
View
larger picture
|
| |
*Center
Bearing Bracket and Coupler. |
 |
| |
*Zinc
plated torsion tube. 15 ga 11 ga or solid shaft. |
| |
*Aluminum
cast cable drum. |
| |
*1/8"
(3) minimum diameter Lift Cables. |
|
| Track
|
- Heavy,
Rolled edge Vertical Track.
- 17
ga = to 8' (2440)
- 15
ga = to 12' (3660)
- 14
ga = over 12' (3660) high
- Heavy
Horizontal Track
- 16
ga = 7' (2130) high
- 15
ga = to 12' (3660) high
- 14
ga = over 12' (3660) high
- Heavy
duty, 12 ga, Track Brackets combine with full length Reverse
Angle Shields (Patent Pending). Reverse Bracket Shields
on Montana.
- Fastens
solid to brick, block, concrete, stone, wood, sheet rock,
etc. finished right to the edge.
- Punched
Angle track hangers (Optional).
- Heavy
duty, 12 ga Flag.
|
|
| Unbeatable
Weather Protection |
| |
*Heavy
24 ga Steel (Montana panels are 26 ga) |
View
larger picture |
| |
*2"
(51mm) Thick Integral Design. |
| |
*Both
sides of every Martin Door(except Montana) |
| |
*have 3 coats of unbeatable weather protection:.
| |
1st
coat - Hot dipped G60 galvanizing to help prevent
rust |
| |
2nd
coat - Thick coat of baked on enamel paint |
| |
3rd
coat - Thick coat of baked on enamel paint |
|
|
| Premium
Rollers and Hinges |
View
larger picture |
- 14
ga, Low profile hinges are heavy duty.
- 12
ga Roller Brackets.
- Amazingly
quiet, 11 bearing steel rollers with special formula nylon
tire and Roller Shield™(Hardened
inner & outer racepacked
in high/low temperature grease.)
|
|
 |
|
 |
High
Wind Areas
|
|
 |
Environment
Friendly
|
| Martin
Series II Doors are built to wind load standards set by DASMA
pub. #102-1976 and ANSI Bulletin A216.1 1977. |
Insulation
is not bonded to door sections allowing for section repair/recycling |
| Insulation
is removable, reusable and recyclable |
| Note:
For Extreme High Wind areas, Martin Doors can be upgraded
to specific wind loads. |
Martin
Doors are friendlier to our trees |
|
|
|
| |
 |
|
| |
|
|
)
)
)